Large-Format ITO Heater Glass for Industrial HMI Display — Korea Case Study

Large-Format ITO Heater Glass for Industrial HMI Display — Korea Case Study

Summary

A Korean industrial equipment manufacturer needed a heated front glass for their HMI terminal to prevent condensation on a 724x418mm TFT display. Felix Glass supplied a custom ITO-heated soda-lime glass cover at 5 ohm/sq, powered from a standard 24V DC rail, with edge busbars keeping the display aperture clear.

A Korean industrial equipment manufacturer needed a heated front glass for their HMI (human-machine interface) terminal. The display operates in an environment where temperature and humidity swings cause condensation on the cover, fogging the underlying TFT panel. Off-the-shelf ITO heater glass was not available at the required size.

The challenge

  • Large cover format: 724 × 418 mm — beyond the standard size range of most ITO-coated glass suppliers
  • Active heating from a 24V DC control rail, without adding a separate power supply
  • Optical transparency preserved for the TFT display beneath
  • Opaque contacts kept outside the display's active area

Felix Glass solution

We supplied a custom ITO-heated soda-lime glass cover with the following build:

Format724 × 418 mm
SubstrateSoda-lime float glass
ITO sheet resistance5 Ω/□ (low-resistance film)
Busbar layoutTwo opposite 724 mm long edges; clear aperture kept contact-free
Calculated terminal resistance≈ 2.9 Ω (at reference temperature)
Supply24V DC
Calculated rated power≈ 200 W across 0.30 m² (≈ 660 W/m²)

The low 5 Ω/□ sheet resistance was chosen deliberately: at 24V it delivers enough heating power to clear condensation on a large panel within a reasonable warm-up time, while the edge busbars keep the heated contacts out of the TFT viewing area.

Outcome

The heated cover was integrated into the customer's HMI terminal. The existing 24V control rail powered the heater without additional conversion electronics. The large-format ITO coating was produced and inspected in-house, with sheet-resistance mapping and optical transmission verified before shipment.

[Placeholder: insert one measured result here — e.g. "In chamber testing at 25°C / 85% RH, the panel cleared fogging within ___ minutes." Only include this if the chamber test was actually run.]

Why this project is representative

Most off-the-shelf ITO heater glass is offered at 100–300 mm formats with sheet resistances of 10–100 Ω/□. A 724 × 418 mm panel at 5 Ω/□ requires coating-line capability and sheet-resistance uniformity that smaller suppliers cannot guarantee. The project shows how a low-sheet-resistance film, paired with a standard 24V industrial rail, turns a conventional HMI cover into an actively de-fogging window.

Related resources

Request a Similar ITO Heater Glass Quote